11/11/2015 | 1 MINUTE READ

Additive Manufacturing’s Assist to ID Grinding

Facebook Share Icon LinkedIn Share Icon Twitter Share Icon Share by EMail icon Print Icon

Additive manufacturing helped Norton/Saint-Gobain achieve better cooling in a grinding application.

Share

Facebook Share Icon LinkedIn Share Icon Twitter Share Icon Share by EMail icon Print Icon

ID grinding involves machining a bore using a grinding wheel nearly as large as the bore itself, as shown in the large photo above. Coolant has to reach and cover the wheel through the narrow space between the wheel and the part. It often fails to do this, particularly on deeper bores than the one seen here, so the detrimental effect on surface quality and cycle time resulting from inadequate cooling is an accepted fact of life in ID grinding.

Grinding wheel maker Norton/Saint-Gobain wanted to learn if it really did have to accept this. The company fabricated compact nozzles slender enough to reach deep into the narrow space between the workpiece and wheel. Early nozzles were made through bending and welding metal, but these didn’t control the high-pressure flow adequately to direct it at the wheel. To achieve this control, the narrow nozzle would need contoured passages inside. The resulting design was too complex to fabricate, but the company was able to grow it in one piece using direct metal laser sintering (DMLS).

The nozzle made in this way is seen in the photo at top left. The illustration just beneath it shows how this nozzle reaches fully into the small space between the part and wheel. The image at the bottom shows the detail of the internal passages that direct the fluid.

Testing with this nozzle showed that it enabled finer ground surfaces and faster grinding times compared to standard nozzles. While additive manufacturing is often associated with a poor surface finish, here is a case where it delivered a finish improvement.

Learn more about this application at short.additivemanufacturing.media/idgrind.

RELATED CONTENT

  • Highlighting Hybrid Manufacturing

    The winner of the first International Additive Manufacturing Award is a company that developed a head for adding metal additive manufacturing to an existing machine tool.

  • The Future of Manufacturing

    According to engineers with GE Aviation, the challenges of additive metal manufacturing—serious as they are—are small compared to the promise that this technology holds. How else can you make a plane engine 1,000 pounds lighter?

  • 10 Valuable Lessons from an Additive Metal Part

    If you’re going to use AM for production, the subtractive steps deserve as much consideration as the additive cycle.


Resources